Connecting to Fresh Water

1. Locate the city water connection on your RV (usually on the driver's side).
2. Make sure all inside faucets are closed.
3. Connect your drinking-safe water hose to the campground water supply.
4. Run water through the hose for a few seconds to clear any debris.
5. Connect the other end of the hose to your RV's city water connection.
6. Turn on the campground water supply slowly.
7. Check for any leaks at both connection points.
8. Turn on an inside faucet to release any air from the lines.

Using the Fresh Water Tank

If you're not connected to city water, you can use Frida's onboard fresh water tank:

1. Locate the fresh water fill connection.
2. Remove the cap and insert your hose.
3. Turn on the water and fill the tank (watch the monitor panel to avoid overflow).
4. Replace the cap when done.
5. Turn on the water pump using the switch on the control panel.
6. The pump will pressurize the system so you can use the faucets and toilet.

Water Conservation Tips

• Turn off faucets while brushing teeth or washing dishes.
• Take short "navy showers" - wet down, turn off water, soap up, then rinse.
• Use paper plates when convenient to reduce dishwashing water usage.
• Keep a water container handy for drinking water to avoid running the tap.